Quote:
Originally Posted by mgoorevich
Ok the most simple case:
On the volume graph make selection. With a trim tool decrease the volume to -10 db.
Now try to perform the Glide to current command by selecting area from 0db to -10 db.
In my situation even this does;t work. And yes, in auto enable window, the volume is enabled.
|
"volume graph" : you mean Track View set to volume ?
You CANNOT use glide-to-all-enabled making selections of areas containing existing automation (anymore).
Try this :
one clip , volume 0
selection of clip , write to all enabled (volume only in automation window)(to add breakpoints at start and end)
now : selection middle of clip to end of clip
fader (not the volume line in the edit window !), move to -10dB
glide-to-all-enabled
result : from the middle of the clip to the end the volume goes continuously from 0 to -10
The ref guide talks about using the VOLUME FADER, not the volume automation lane line, NOT about using the TRIM TOOL, it is about using the knob/fader/poti parameter.