Re: Is there way to calibrate the S1 faders?
This is not a matter of calibration but just the way the IC controller and faders behave. You have to go to much more expensive IC controllers and faders to achieve better positioning. The Artist Mix had the same issue as does the new SSL controller (look at their promotional videos). You are moving a fader via a simple motor and rubber band at high speed, the code to get this as close to the correct position is very complex. If it were a stepper motor(way to big) then it would be easy. That said we are currently looking at the S1 fader firmware to see if we can make any improvements.
|