I am new to ProTools LE 8. I just bought the software and installed it. Now the installation instructions tell me to launch the PT software and authorize it, only problem is when the software starts to load all of its plug-ins the process stops on AutoTune.dpm and displays this message.
"Could not complete your request because Access violation occurred, unable to read location: 0x0D,215,A4F at address: 0x75,475,74D in module: MSVCR80.dll"
As I'm sure some of you know, just by reading some of these threads that now the process will not continue and I have to Ctrl+Alt+Delete to get out of the launch process. Can somebody give me any suggestions on what to do, I have already tried uninstalling and reinstalling PT. Thanks a lot.
