Re: Hardware settings not saved?
I'm running 2022.4.0
I will double check my cables but after making the selection for Word Clock (96k) it says everything is fine and I don't have any sync issues - so the cable seems OK once the setting is correct.
Its odd - as some times the pop-up shows up almost immediately after opening PT and other times it appears after opening a project.
In either case, the response to correcting the setting is the same and it goes on to work fine -
I can open and close various projects and the issue remains solved - but close PT and restart PT - the issue returns.
The clock "circuit" is very short - just the one cable from the RME to the Omni and its short - under 3' with a decent BNC cable.
As long as this is the only ghost in my machine, its a fairly benign one.
Mark
|