Re: DADman Patching
Hi Jeff,
''Within the DADman software'' not ProTools - via HD Native DigiLink 1,2 a metering signal flow is going from a source/input > Destination/Output the first 12 channels to 1 then 12 channels to 2 in Pri/Pri mode.
What I find after creating a DADman profile once its connected and I remove the signal/input flow by deselecting a (Blue Dot) if I try to reconnect the metering again (Blue Dot) my audio signal is no longer heard coming from that source input patch point.
Can a .dms profile be custom configured without importing an older configuration to build a new source and destination routing using the CON section of DADman. How could I make quick changes to create my own custom profiles for pre listening to the metering signal flow and monitor outputs using DADman 5.6.3.
Regards
|