H.G.
I reinstalled eucon 3.0 following the release note you provided. The fader pack were successfully updated.
I opened a few sessions on PT11 and the fader packs were working fine apart from a few bugs:
1-If you use the pan knobs they send data to PT but you have zero feedback on the FFT display and on the pan knobs itself (it always display the center value even when turning the knobs). So the automation is working but without feedback.
2-The Aux sends have the same behaviour. they send data to PT but you have zero feedback on the FFT display and on the send knobs (they always display the -inf value even when turning the knobs).
3-You can't load a user set done in PT 10.
Apart from those little bugs the system 5 MC seems snappier.
I have another start up disk with PT 10.3.4. Is this version compatible with eucon 3.0?
I guess my other options are:
Plan B : Install 10.3.6
Plan C : Stick with PT 10.3.4 and go back to eucon 2.7...
Thanks!
