[Dazed]

I have run the HD system for two years with great success! I recently added the 002R and Digimax LT for remote recordings. I though I knew a little someting about Protools until I tried to get the two to talk. The problem is when I setup the 002R to be the slave and set the Digimax to Master, at any clock rate, the 002R does not see it nor will any of the channels from the ADAT inputs (9-16)display any evidence of a signal when you can see the channel active on the Digimax. The physical connection seems to be correct between the two with the ADAT optical cable coming from the Digimax to the IN ADAT on the 002R.

Hardware settings on the 002R are set to External clock with Adat (this fails and reverts to Internal).

Thank you Thank you in advance!!!