Re: Midi Interface for use with ProTools Sequencer
Cheers guys
I think the reason you have no problems with the Midisport device is mainly due to the problems occuring when its used in conjuction with a control surface.
I noticed no control surfaces were listed in your kit list.
If I disconnect my motormix everything is fine (I have also tried another motormix and a Mackie control to no avail, which eliminates the motormix as the culprit) so its most likely a problem with the constant midi stream back and forth between controller and interface that causes lockups.
I have trawled through posts relating to this issue and I think I'll trade in my midisport for an Emagic MT4 interface
Freakybeatz
|