Quote:
I am getting signal now into my headphone unit, my mistake but the problem is even wierder than i thought.
My control room level is affecting the cue1 level to the headphone unit, i had my control room level turned down when i was checking the cues so I thought there was nothing there.
So my main outputs and my cue outputs are not working independently of one another unless I select Mn as the source for cue1 in, then they work independently.
The meters on the d-command and on the 192 dont change when I turn down the control room, rightly so but the actual signal level for cue1 does change.
|
This sounds very strange. I have two D-commands and the monitor level and the cue level are definitely separate. I have never experienced this. There is a way to reset the whole D-command system (I believe you have to hold these keys down on ch 1 while turning on the unit "select+solo+mute"). Try that if all else fails.