View Single Post
  #1  
Old 03-01-2022, 08:58 AM
leoaudio13 leoaudio13 is offline
Member
 
Join Date: Jan 2009
Posts: 13
Default HD Native + Lynx hilo + HD IO + 192 IO + HD Sync

Hi all,

I'm using Hd Native PCIe with configuration as below :
- HD Sync as Master Loop sync , receiving clock master from Hilo.

- HD IO (16 analog in - 16 analog out ) on port 1 using mini digilink ( long cable from Avid ) , 192 IO ( 8 analog in - 8 analog out - 8 AES ) to expansion port on HD IO
- Hilo on Port 2 via LT-HD card.

The problem : with above config, HD IO, 192 IO and Hilo recognized fine in PT Ultimate 2021.7.0 with A , B and C respectively. However, when I sent a tone from 192 IO and route it back to the same 192 IO I can see the output/in LED shown on the interface but no signal is shown in Pro Tools.
As in attched pictures, I'm trying to route from output 1 of 192 IO back to Input 2 on 192 IO. LED meter showing signal present but in PT , nothing! HD IO, Lynx receive signals just fine! Very weird!


Please help!
Attached Images
File Type: jpg Bus.jpg (30.2 KB, 0 views)
File Type: jpg Hardware.jpg (40.2 KB, 0 views)
File Type: jpg Input.jpg (34.0 KB, 0 views)
File Type: jpg IO.jpg (36.9 KB, 0 views)
File Type: jpg 274062894_1031546821043490_1025684777970379848_n.jpg (59.2 KB, 0 views)
Reply With Quote