Thread: Not seeing SYNC IO in "session setup"
View Single Post
  #1  
Old 11-03-2011, 04:13 AM
mistermed mistermed is offline
Member
  
Join Date: Nov 2011
Location: london
Posts: 2
Default Not seeing SYNC IO in "session setup"
This is the first time I've hooked up a SYNC IO unit. I have connected loop sync and serial cables. The MAC has recognized the unit in Digitest, and I have successfully done a firmware update, and the SYNC IO is now running V1.2.1.
The SYNC IO is locked and I can see external incoming timecode on the display.
I have assigned "Pro26IO" as the MTC reader port in Peripherals / Synchronization window (as this only appeared after the firmware update so assume that's the correct device), however there is no soft settings available to me in the SYNC or TIMECODE dropdowns of the session setup window?
I just need it to chase to external timecode from another source.
Any help appreciated.
Reply With Quote