[dubaifox]

I know, I have a clock syn problem, but this seems a little complicated and I can't figure out the problem

I have an Apogee Rossetta96 sending ADAT clock in to my Digi 002r

I then have an ADAT cable going from the 002r to my 01v96 mixer, and it says that there is a valid clock source being recieved and it IS in sync.

Pro Tools seems happy with the set-up, as it never reverts to internal clock. (I have it on the ADAT option in the hardware set-up.)

The pops seem to get worse the longer the system is on. The pops are not printed on the audio files but are some artifacts that randomly occurs in this set-up. I am using "Artist Drums" and it seems to happen worse with that in the mix.

Anybody have any ideas?