[creativecontrol]

Greetings,

When interfacing MTRX Studio with HDX or HD Native, there are a few different ways you can deploy.

1. With a single HDX or HDN, connect both 32-channel DigiLink ports to both ports on the engine card for 64 channels of IO - which could be any complement of analog, ADAT or Dante. DigiLink Mode = Pri/Pri.

2. Connect one 32-channel DigiLink cable from port 1 of HDX or HDN to port 1 on MTRX Studio for 32 channels of IO. DigiLink Mode = Pri/Pri. Connect additional (up to 2) Avid IO to the 2nd port of HDX or HDN.

3. Connect one DigiLink cable from port 1 of HDX or HDN to port 1 on MTRX Studio for 16 channels of IO when in Pri/Exp mode. Connect port 2 of MTRX Studio (expansion) to primary port on HD IO. Each interface is providing 16 channels of IO for 32 channels total. In this scenario, 2 additional Avid IO could be connected to port 2 of the HDX or HDN engine.

Hope this helps.


Jeff



Sent from my iPhone using Tapatalk Pro