Re: EUCON, PT crashes after setting up PFL/AFL routing.
Create a session on a TDM system with eucontrol 3.1. and an OMNI interface. (artist mix/control connected). I am using a HD5 rig at the moment.
Have tried this with only a HD MADI interface also, same crash.
When you start, make sure it is the default solo in place monitoring and no PFL/AFL patching.
Create 64 audio tracks and add EQ7 DSP plug-in on all of them from the artist surface.
Fiddle around with different tracks a bit and adjust EQ parameters.
Now, switch over to AFL monitoring, PT ask you to setup AFL/PFL patching.
Setup AFL/PFL to output 7-8 on the OMNI and that it should mute output 5-6 when in solo mode.
Hit ok.
Start to select different tracks in a fairly rapid way with the EQ focused.
After a while PT crashes.
Happens everytime for me.
Have tried on two different computers, same crash, even with just the original plug-ins loaded.
It was a little better on eucontrol 3.0, but its gotten worse on 3.01 and 3.1.
|