View Single Post
Old 01-16-2021, 08:37 AM
superfeed superfeed is offline
Join Date: Aug 2020
Location: 3872 Arbutus Trl
Posts: 3
Default Re: Pro Control Main Unit Meters and Counter Freeze

I took both connectors (ribbon cable and Molex) off the meter/counter board last night and spayed out the connectors with de-oxit. Also pulled other end of ribbon cable where it attaches to circuit board and sprayed that too. I bent Molex pins of meter/counter slightly in middle. After reassembly, system worked without freezing up for several hours.

I have been into this main unit several times chasing bad solder joints and loose Molex contacts.

System (while well used) is new to me (as well as Pro Tools). Looking forward to reliability and getting a little higher on the learning curve.

Thank you for your help!

Reply With Quote