View Single Post
  #7  
Old 08-11-2022, 08:56 AM
mab780 mab780 is offline
Member
 
Join Date: Jan 2022
Location: Devon. UK.
Posts: 14
Default Re: D-Command faders not working

Unfortunately, none of the fader tests in the Utility menu do anything. The faders on the main unit all appear to be dead. Those on the 16 Channel expansion module continue to work fine.

The lights for automation, alongside each fader on the main unit still work perfectly, but obviously, I can write automation with the physical faders.

As I mentioned, I have tried swapping out the Fader motor PSU, but that had no effect either.

I am beginning to think that it may be a firmware problem because when I access the Utilities menu, I can see the Console is showing up as v10, but there is no version showing for the Motor functions. I am sure this used to show up as v10 also.

Does anyone know how I can restore these values, so that the Motor control can be restored to V10 too.
Reply With Quote