[abc1mce2]

Originally Posted by K Roche

Here is what I do

#1 ....I run my 2 outboard hardware FX units as Hardware I/O "Inserts" (see my session Mix window below), I do not "Bus out" to them, and when using them parallel, I place them on Aux Input tracks, not audio tracks . And since I send to them from audio tracks that I have put into DSP mode, (and they are associated downstream tracks) they automatically get put into DSP mode

#2 Don't run any ADAT so can't comment from personal experience .... But I am guessing yes .. I know a small studio owner who has Carbon and I think uses ADAT so I will ask him

#3 Yes very easy launch PT > Setup > Hardware > Line I/O tab. (see mine below)
I use 1-4 for microphones thru Carbons pre amps and then 5-8 Bypassed for my two 2 channel Hardware units ,, a Comp and a Reverb . (also note) If you have not done it ? I suggest google "Avid Carbon User Manual" and down load it . It's the best manual Avid has put out..




Here my two hardware units are on Aux Input tracks righthand side labeled M7 (reverb) and 2 Mix which is my session 2 Bus

Orange arrow showing sending from my Acoustic Rhythm Guitar -Routing Folder track, to my Reverb track

I would like to see the pictures but they don't appear. Could you please re-upload the pictures?