View Single Post
  #1  
Old 02-19-2011, 04:26 PM
Kelly Vaughn Kelly Vaughn is offline
Member
 
Join Date: Dec 2009
Posts: 24
Default Install Driver for Mbox Pro 2 and PT9...help!

I have installed the drivers for my Mbox 2 Pro...firewire not usb. Then ran the pro tools 9 upgrade setup. Launced and said my interface wasn't connected. Said to connect and hit ok...I did but nothing. So I installed the proper driver again just to make sure. Launched and same thing...it doesn't recognize my interface.

So...

I am going to unistall pro tools completely...upload the proper driver again...then run the full installation of Pro tools 9. Oh...and i will have my ilok key in with my pro tools 9 authorization on it.

I'm hoping this will allow me to run the program. Any thoughts or ideas on this?


I was also under the impression that pro tools 9 would run without being connected to an interface. I just wanted to mix some tracks and bounce some files. Why does the interface need to be connected.

Thanks so much fellow recording enthusiasts.

- Kelly
Reply With Quote