Quote:
problem on Fader #8. Makes a repeated clicking noise at the bottom of its throw after the unit is powered up. Fader utilites & calibration don't change the story. Only registers values between 1012 and 1023 and tries to stay at the bottom of it's throw for 1012 and near the "0" mark for 1023.
Updated to latest firmware. No improvement. Cracked it open; disconnected fader #8 and connected fader #7 to the #8 set of pins. The problem stays in slot #8. Must be the mother board. Connected fader #8 to position #7 and it worked fine.
Are fader problems almost always the mother board? Have you had a mother board replaced? What was the cost?
j mcd
|
I have this EXACT problem with my Command|8 except it's 'fader #4.'
Same symptoms, just moves between 1012 & 1023 (over the length of the fader throw) and clicks repeatedly at the bottom of the fader throw.
It just seems like it's mis-calibrated. The Fader Cal & Utilities have been no help? I have the latest firmware 02.01.02.
The unit's serial is UK0414500G
Is this a known problem? Should I contact support? Anybody?