[perh]

I've upgraded to 10.3 and Mountain Lion...

This is regarding automation. And I can't remember if it's always been like that on earlier version(s):

When I alter an automation breakpoint - clicking on the breakpoint won't show the value(above the mouse cursor) until I actually drag the breakpoint - but then it's obviously a new value. So I have to guess a breakpoint's value, since it won't show when just clicking on it..
I can of course move the playhead to the breakpoint's location and read the value on the(in this case) volume slider or volume i/o..
I can't remember if it's always been behaving like that. I'm not sure, since it is seems rather stupid...

Can someone confirm or maybe check it on a version prior to 10.3 and ML?

Thanks...