DSP Pilot crashing when changing mixer model
1 Attachment(s)
eMix 6.0
System 5 Fusion Dsp crashes when I change mixer model from 96k to 48k. Any ideas? |
Re: DSP Pilot crashing when changing mixer model
Pretty sure the DSP Pilot should not be running when you change mixer model. After you change the model do you power down EVERYTHING and restart ?
|
Re: DSP Pilot crashing when changing mixer model
Also latest version is 6.1
|
Re: DSP Pilot crashing when changing mixer model
5 Attachment(s)
Dsp Pilot is running in the background all the time....
Connected is 401, 408, switch, SC264, Sync HD set to 48k int. |
Re: DSP Pilot crashing when changing mixer model
5 Attachment(s)
123
|
Re: DSP Pilot crashing when changing mixer model
2 Attachment(s)
123
|
Re: DSP Pilot crashing when changing mixer model
Doesnt really answer they question....if you restart the whole system is does the new mixer model work ?
|
Re: DSP Pilot crashing when changing mixer model
Quote:
Could the install be missing something? |
Re: DSP Pilot crashing when changing mixer model
Can you try and get me the logs (i'm not sure where at the moment, but can find out tomorrow)
|
Re: DSP Pilot crashing when changing mixer model
Found it. Was the Pilot 1 Properties/General/Source and Base Rate that was set wrong.
All good now 😁😁 |
All times are GMT -7. The time now is 02:15 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com