003 Replacement?
Does anyone know of a good FW board compatible with protools 11?
I'm looking for a compatible console with physical faders to replace my 003 console. My setup now: Mavericks 10.9.4 MBP 15-inch (Late 2011), 2.4.GHz Intel Core i7, 16 GB RAM Focusrite OctPre MK II Dynamic Digi 003 Console 003 driver 10.3.3 Protools 10.3.9 |
Re: 003 Replacement?
Good luck:eek: For control surfaces, there's not much to choose from(personally, I have high hopes for the Behringer X-Touch, if they ever actually ship them). Artist Mix and/or Artist Control are worth a look, but do cost more. I just replaced my 003 with an HDN package, and while I do miss the surface, my little Presonus Faderport covers transport, quick-punch and fader rides just fine. In fact, the button I miss the most: SAVE:eek::p
|
Re: 003 Replacement?
Do you need I/O from the new interface or just fader's/pan/plugin, etc,. control?
Look at the Focusrite Control 2802: "The best of both worlds! The Focusrite Control 2802 is both an analog mixer and a DAW control surface. Eight high-bandwidth, low-noise Class A mic preamps start the signal chain of this dual-layer mixer. A total of 32 inputs is possible, so you can record as large an ensemble as you want. The Control 2802 also adds a stereo mix bus compressor, a myriad of routing options, and motorized 100mm Alps faders to your studio - in one complete package. This high-end analog summing mixer also features phantom power, a full-featured master section, dedicated stereo bus cues, and a 10-LED channel meter for ease of use." http://www.sweetwater.com/store/detail/Control2802 Hope this helps |
All times are GMT -7. The time now is 06:36 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com