Avid Pro Audio Community

Avid Pro Audio Community (https://duc.avid.com/index.php)
-   003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) (https://duc.avid.com/forumdisplay.php?f=15)
-   -   Signal peak/distortion/db meter peak when recording enabling track on Pro Tools LE 8 (https://duc.avid.com/showthread.php?t=324798)

hotgravy 06-30-2012 10:49 AM

Signal peak/distortion/db meter peak when recording enabling track on Pro Tools LE 8
 
Hello!

I have a strange yet consistent issue with my Pro Tools LE 8/Mbox 2 Mini setup.

I'll finish working in a session and close down Pro Tools. When I go to reopen Pro Tools in either that same session or any other one, create a new track and record enable it then the db meter peaks into the red and there is loud distortion on the track. This will happen no matter how many tracks I open. If I shut down Pro Tools and physically unplug the connector from the back of the Mbox 2 Mini that connects to the USB port on my Mac Mini and plug it back in I can then restart Pro Tools and the issue is gone.

Basically, every time I start a new Pro Tools session I have to unplug the Mbox and plug it back in again. That signal peak happens every time I don't unplug and replug the Mbox 2 Mini without fail. It's not a major issue but seems like I shouldn't have to do that each and every time I start up a session.

Info on my system and setup are below. If anyone has any ideas I'd be grateful to hear them.

Thank you!


-------------------------------

Mac Mini
Mac OS X
Version 10.6.8
Processor: 2.4 GHz Intel Core 2 Duo
Memory: 2GB 1067 MHz DDR3

Digidesign Mbox 2 Mini
Pro Tools LE 8 - Version 8.0.5
Connected to back of Mac Mini via 6 foot USB cable (have tried various cables with same effect)
No other peripherals.


All times are GMT -7. The time now is 09:47 PM.

Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com