how to get 4 x hardware inserts with AVID OMNI / PT HD
 

I have an Avid HD OMNI and PT Native Thunderbolt card.

I'm trying to set it up so I can use 4 x hardware inserts on the OMNI but because of the "stereo monitor" path it doesn't seem to let me.

has anyone been able to get this to work? is it possible?

i am trying to set it up but it won't let me change where the MONITOR is assigned.

http://s3.postimg.org/w3055ed4j/Scre...0_05_11_PM.png

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

Inserts have to be match pairs so if all your inserts need to be analog you'll need an DA/AD pair to use an AES I/O pair
But I don't have any Omni experience so I don't know

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

is there any way to unlock the "stereo monitor" from being the output 1-2.

even when i change it to 7-8 in the monitor panel, it still won't let me change 1-2.

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

This still bums me out :(

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

I sure wish Avid had either limited the OMNI more(so fewer would buy it and be disappointed) or allow it to do 16 IO total:cool:. The HD 8x8x8 IO and a monitor controller is a much better option for far too many users:o

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

You should be able to disable the monitor in the Monitor Tab section. That will give you 8 analogue outs and 4 ins.

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

Outoftune,

Here is the old thread I mentioned that I would try to find:

http://duc.avid.com/showthread.php?t...ht=omni+insert

On the second page, Psychomonkey found the solution, which I'll copy here:


"worked it out eventually!

For anyone else still struggling, you have to have:

Monitor Path on 7-8 (or 5/6, but I'm using the TRS mirror so can't do it on 5/6), under Hardware Setup - Monitor Tab.

CRUCIAL POINT I WAS MISSING:

Under Hardware Setup - Main tab, you HAVE to have a path other than 1-2 assigned to physical outputs 1-2. In my case, I'm using path 5-6 with physical IO 1-2.

This is the confusing part! With the OMNI, you can have physical IO routed so PT sees it differently, but the Monitor path is fixed to 1-2.

Oh, and it helps to have 1/2 set to "line" on the front of the OMNI...that foxed me for a bit!

Hope that helps anyone else struggling!"


This relates to what I was mentioning in another thread you posted (maybe on Gearslutz), in which I mentioned that Monitor 1-2 is just a designation that does not always correspond to output 1-2.

Re: how to get 4 x hardware inserts with AVID OMNI / PT HD
 

hi everyone, thank you for the input i'm going to try this.