Master Fader 6.7 Master Fader issues
Has anyone had a problem with the master fader not working after adding a plug-in in 6.7 LE. I have added the EQ III plug-in in a session and there is no master fader output, there doesn't appear to be any signal going to the master fader after the plug is added, all other faders appear to work normally. I save the session, close Pro Tools and open the session and everything work properly. Are there any known issues with this?
Thanks Jim |
Re: Master Fader 6.7 Master Fader issues
Interesting for sure. I don't have a real answer. Maybe this is due to the fact that EQIII was released for 6.9 and it only "sort of" works with earlier versions? In any case, my recommendation is to save master EQ for seperate mastering whether you use protools or another program. I go back and forth between PT and WaveLab and find both work very well. After using master faders on a few projects, I have stopped using them completely now. If I need a fade, I do it in my mastering session where I also trim the start and end of the final mix. Since I don't consider myself a mastering engineer, I tend to keep it simple and usually only put a little Waves L2. I rarely use master EQ but like anything else, YMMV.
|
Re: Master Fader 6.7 Master Fader issues
Are you in Low Latency Mode?
Rail |
Re: Master Fader 6.7 Master Fader issues
Rail, I have only had this problem when mixing and not in low latency mode.
Jim |
Re: Master Fader 6.7 Master Fader issues
Quote:
Jim |
All times are GMT -7. The time now is 05:42 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com