Expand Zones and Display Modules
 

Hello all!

Is there any way to stop the Display Modules from being linked to the auto expand knob zones?

I like to work with my Displays in Waveforms and Dual Function Layout. However, I can only get this by turning off my expand knob zones. Otherwise, the display reflects the parameters of the expanded EQ.

Re: Expand Zones and Display Modules
 

Greetings. Currently the Enable Exp Knob and Enable Exp Fader Soft Keys toggle the zones between global and On Attention behaviors. Standard display modules (not Master Modules) in their respective buckets follow the state of the modules. I suppose you would need another preference to tell the displays not to show an expanded view which would maintain your previous (dual function) view.




Jeff

Re: Expand Zones and Display Modules
 

Yes! Exactly. The soft key is a good quick way around this though. Thanks!

Re: Expand Zones and Display Modules
 

+1 - i believe i mentioned this in another thread but having all the knob information on the display module is not as visually intuitive as maintaining the strip information

Re: Expand Zones and Display Modules
 

+1 on this

Re: Expand Zones and Display Modules
 

I will add a pref for this in a future release then.

Re: Expand Zones and Display Modules
 

Please add a pref so that the CDMs can follow state. Just ran into this today and it was fortuitous that someone else brought it up.

Re: Expand Zones and Display Modules
 

Hi,

I know it's an old one but it's this kind of behavior I need too : using auto expand eq (perfect with fab filter eq) but still having the display module showing the curves of all the strips of my current layout.

Please think about it Avid folks (and sorry for some English mistakes...)!

Re: Expand Zones and Display Modules
 

+1 This would be a huge improvement for current workflows.

Re: Expand Zones and Display Modules
 

Sorry this is taking longer than expected. Its our case number GWSW-13905 so I can keep track.