Powered USB hub issue
I'm chasing an issue with a high pitched noise I get when PT starts up with my mbox2. I've read the issue might be solved by using a powered usb hub instead uf the usb connections on my imac.
I bought a 4-port Kensington hub and connected the mbox2 to it and from there to the imac. Now Protools appears to open but will not play, neither will itunes. When I hook it back the way I had it, still get the noise, but all works fine. When I go back and reconnect the Kensington, I get the following error message- "PT cannot communicate with the mbox2. Please make sure the mbox2 is connected and not set to AC-3 mode. I checked prefferences and AC-3 is not checked and it says the mbox2 is connected. I've searched the issue but not finding anything." and... "PT could not set sample rate to specified value" Any ideas? |
Re: Powered USB hub issue
From Digi:
"Mbox is designed to work on a single, dedicated USB port build into your computer. We do not support its use on any hubs, adapters, expansion cards, or the USB port on the side of your USB keyboard." |
Re: Powered USB hub issue
Really? Very interesting. I guess that leads to my next question, which is anyone else experience a this, low volume, high pitch noise when protools boots up? And if so what can be done about it?
|
All times are GMT -7. The time now is 01:46 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com