32 fader icon stand
As the title says. I’m looking for the stand/legs to an icon d-control 32 fader. If you have one or know of one, hit me up! Thx
|
Re: 32 fader icon stand
I have a blue stand that I don’t need. PM me if you are interested.
|
Re: 32 fader icon stand
PM sent. Thanks!
|
Re: 32 fader icon stand
Bump.
Looks like my original source may not have a 32 but rather 16. Still looking |
Re: 32 fader icon stand
If you have the 16 fader stand legs you can probably have a metal Smith fabricate the longer pieces to join the different sections for a 32 fader icon.
Sent from my SM-G986U using Tapatalk |
Re: 32 fader icon stand
Yea it might be last resort, the problem is the cost. Once I dish out the cost for the 16 fader stand I’m pretty sure a metal
Shop would charge a pretty penny to make Those rails, can’t imagine anything less than. $2-300 |
Re: 32 fader icon stand
Quote:
Will be a very tough job. But really the only way if you can't find the proper stand. The metal would in itself be expensive. I had custom rack furniture made to spec to fit my studio and that kind of stuff is expensive to get done. Sent from my SM-G986U using Tapatalk |
Re: 32 fader icon stand
Found a fabricator that’s meeting with me tomorrow. Objective is to split the 16 fader rails and lengthen them to accommodate two additional fader buckets to bring it to 48 fader. For a good fabricator/welder I can’t imagine it Will be too difficult
|
Re: 32 fader icon stand
Hi,
Not sure if you managed to get a 32 Channel stand but, I have one and am after a 16 Channel stand. London based. Sent from my J8110 using Tapatalk |
All times are GMT -7. The time now is 07:23 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com