"Bus error" in thread "MainThread", at address 0x0
Hi there,
I installed PT9 drivers for my MBox2 mini from the drivers disk in the package, then installed the software from the software installation disk in the package, then I authorized and transfered the license onto my ILok from my account, but when I launch PT9 this message come up: "Bus error" in thread "MainThread", at address 0x0 Anyone knows what is this about? Thanks |
"Bus error" in thread "MainThread" at address 0 x 0
Hello, I just got this bug and fixed it, after reqding qbout the subject here I could not find any solution so I started reading the error report from apple.
It seems to have been caused by Automap, I recently intalled it with my new Novation Nocturne midi controller to use In Ableton Live and I enabled all my plug-ins in automap, so I unchecked them all and was finally able to run protools smoothly, I will do some more test to see if I can run it in Protools. Hope this was helpfull to at least one person out there... |
Re: "Bus error" in thread "MainThread", at address 0x0
Hello, I just got this bug and fixed it, after reqding qbout the subject here I could not find any solution so I started reading the error report from apple.
It seems to have been caused by Automap, I recently intalled it with my new Novation Nocturne midi controller to use In Ableton Live and I enabled all my plug-ins in automap, so I unchecked them all and was finally able to run protools smoothly, I will do some more test to see if I can run it in Protools. Hope this was helpfull to at least one person out there... |
All times are GMT -7. The time now is 01:27 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com