Pro Tools M-Powered 7.3.1 Update for Windows XP
 

Download and details here:
http://www.digidesign.com/index.cfm?...4&itemid=24455

Pro Tools M-Powered 7.3.1 Update for Windows XP
For M-Audio Systems with Pro Tools M-Powered 7.3

Who Should Use Pro Tools M-Powered 7.3.1?

This update is required to avoid potential data loss when using a large number of regions or duplicate regions. This update is recommended for all Pro Tools M-Powered 7.3 users on Windows XP and contains fixes in the following areas:

• Bounce to QuickTime movie
• Editing
• Memory Locations

What's Fixed in Pro Tools M-Powered 7.3.1?

Pro Tools M-Powered 7.3.1 for Windows XP contains the following:

Fixed: Launching Pro Tools Could Result in an Assertion (Item #85058)

• The assertion could be dismissed and Pro Tools would operate normally.

Fixed: Using the Smart Tool to Adjust Fades Would Eventually Result in an Access Violation and/or Display Anomalies (Item #85462)

Fixed: Intermittent Corruption After Saving. Closing, and Then Reopening a Session, Regions Were Missing or in the Wrong Location on the Timeline (Item #85755)

• As long as the session remained open, it would still playback correctly and with all playlists intact. The problem would not be observed until the session was closed and reopened.
• Any AutoBackup files created would have the same problem when subsequently opened.

Fixed: Bouncing to QuickTime Movie Could Produce a File Where Audio and Video Were Out of Sync (Item #85906)

• If the bounce duration exceeded the length of the video clip, the resulting movie would be stretched to fit the selection, resulting in a time-stretched picture.

Fix included from Pro Tools M-Powered 7.3cs1:
Fixed: Performing "Undo Add Memory Location" or "Undo Edit Memory Location" Would Cause a Crash (Item #84814)


Available at the link above and in Featured Downloads in the Support section.