Installing PT 8 LE on Snow Leopard
Has anyone successfully installed PT 8 LE (or lower) onto a Mac running Snow Leopard (10.6)? It installs smoothly, but when I try and open it, I get an error: Unable to locate Digidesign hardware." The MBox 2 shows up in the control panel, though. I originally installed Pro Tools on Leopard (10.5) and it worked fine after I updated to 10.6. I recently did a clean install, which is why I'm installing PT again. I'm hoping I don't have to reinstall the OS again, this time starting w/ Leopard, installing PT and then running the 10.6 upgrade.
Thanks, -Adam |
Re: Installing PT 8 LE on Snow Leopard
Make sure you have the correct MBox driver to match the OS version.
|
Re: Installing PT 8 LE on Snow Leopard
Quote:
|
Re: Installing PT 8 LE on Snow Leopard
Could the 1.43 firmware be what's giving me problems? Is there a way that I can downgrade to 1.38 and see if that works?
|
Re: Installing PT 8 LE on Snow Leopard
Quote:
Quote:
|
Re: Installing PT 8 LE on Snow Leopard
Quote:
|
Re: Installing PT 8 LE on Snow Leopard
Quote:
|
Re: Installing PT 8 LE on Snow Leopard
No one has any suggestions? I've been messing around with this for days now with no luck. I noticed that in the Audio MIDI Setup utility the MBox 2 shows up, but it says 0in/0out. So it's being recognized, but there's a problem with the communication. Please Help!!!!
|
All times are GMT -7. The time now is 02:10 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com