Control 24 compatibility
Old issue, can someone please clarify which version of Protools can still run a control 24, and is there a version that will run it along with 3rd party interfaces,
Ie protools xxx with a Focusrite Clarret and control 24. Possible? Thanks in advance. Aj. |
Re: Control 24 compatibility
Control 24 works directly with Pro Tools 10 and older(because there are no 64 bit drivers for it). Neyrinck now has a software utility that makes Control 24(and Pro Control) work on current versions of Pro Tools(I believe it uses HUI protocol), so check out that company website.
followup, I am currently using a Control 24 with PT Ultimate 2021.12 with the Neyrinck software and it works! Any version of PT from 10.x and older would not need the Neyrinck software(but I don't know if any driver is needed). For PT 11 and newer, the Neyrinck software breaths new life into these older control surfaces.:D |
All times are GMT -7. The time now is 10:08 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com