Linking multiple plug-in parameters while maintaining relative values
Say you're half way through a mix, the gain staging is a little off and you want to tweak the output gain of every insert in a drum group, maintaining relative gain values. You can tweak multiple plug-in controls simultaneously by grouping the tracks, but their relative values are lost by doing this.
Any help would be appreciated. Thank you! |
Re: Linking multiple plug-in parameters while maintaining relative values
Put in a trim plugin below the insert (across all channels) and use that. It won't matter if there's clipping on an insert's output gain or not because the PT engine is floating point.
|
Re: Linking multiple plug-in parameters while maintaining relative values
Quote:
|
Re: Linking multiple plug-in parameters while maintaining relative values
Put the tracks in a group with the insert control turned on as a parameter (not globals). Then adjust the automation lane for the output level. They move in relative and not absolute manner. (I should mention that only works with the mouse tool; if you try to write automation with a controller/record automation, it will be absolute values. That is not an issue if you use the trim plugin and write automation to it since it happens after the fixed relative output level of the plugin.)
|
Re: Linking multiple plug-in parameters while maintaining relative values
Thank you for your time BScout.
|
All times are GMT -7. The time now is 03:21 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com