Bouncing Multiple AUX tracks

[walt68]

I'm sorry if this question has been answered but I couldn't seem to find it. I'm still on PT 8. I have a session where I have violins and cellos. I am bussing both of them to two separate reverb aux tracks...each track is being bussed as such...violin track is bussed out 3-4 & 5-6/. cello track is bussed out 3-4 & 5-6.
Then I have two reverb aux tracks with inputs of 3-4 & 5-6 respectively.
How do I bounce both of those aux tracks to a final audio track?
Thx in advance!

[mickelini]

Hi

Simply bus the output of the aux tracks to a new audio track or tracks and record.

Mike

[walt68]

Thanks! So I would set the output of the aux tracks to 7-8 to an audio track where the input are 7-8?

[mickelini]

Correct, assuming you want to mix the aux tracks. You could use separate busses to bounce each one to its own track. (Sorry if this is obvious.)

[walt68]

No it should be obvious to me but it's not!! Thank u! One more question, how would I buss out the instrument tracks, 7-8 also?

[mickelini]

Only if you want them mixed with the aux tracks. Otherwise, use a separate bus to bounce the instrument.

[walt68]

I see, I'm not sure, shouldn't they be bounced to the same track? I guess that's a preference.

[mickelini]

It depends on what you would like to accomplish. Normally, there's no real need to do this unless you're trying to save CPU usage, or just want to set your sounds in stone.

[walt68]

Right, thx again.

[mickelini]

No prob. Have fun.