How Disappointing!

[Hi-D-Ho-Man]

It's pretty upseting that they would exclude the Delta pci series out. I got all excited thinking that i could put my shelved Delta66 to use again to find its not supported

[JPS]

If I were you, I wouldn't necessarily give up. At least not until I downloaded the demo and tried it out with your Delta66. Often times Digi will not support hardware, but it will still work with the software. I used a Gigabyte motherboard and Digi 001 for over a year with the infamous "mixed chipset" (AMD/VIA) and it was a great performer! Perhaps, you'll have the same luck. In fact, I suspect it would work. If Digi is able to get the 2496 to work, which is PCI based, I can think of no reason the Delta 66 wouldn't, unless they purposely made it not to work.

[ZiggY!!]

I understand what you are saying, but im not sure its going to work...

you'll probably get a "digidesign hardware not connected, yadda yadda yadda" message i imagine...

The Delta series is pretty damn old... would'nt surpise me it something new was coming along soon...

but check out the demo and post your findings... it may just work...

[Bastiaan]

try it....i've seen posts of other gear that was not supported being perfectly able to run the demo.....

[Hi-D-Ho-Man]

Whatdayaknow! You guys were right. I installed the demo and it seems to work just fine with the Delta66 pci card. the installer automatically uninstalled the old drivers and replaced them with the new.

I didn't test it extensively tough i recorded 12 stereo using the 4 analog and Spdif inputs and ran a lite reason project thru Rewire no problems so far.

If all goes well after more extensive test, there will be a new item on my shopping list

[Rob Eko]

i got e full version yeserday and it works perfectly with my delta 1010lt

[SeanDerMan]

Hi-D... How did u manage to get PTMP to work on the Delta 66. I downloaded the latest drivers from M-audio, but when i boot up the demo version of PTMP, it says that M-audio hardware is not detected.
I did read somewhere else that the drivers have to be downloaded from the 'digi' site, but I havn't come across any drivers on the digi site.
Thanks

[edytnbch]

does anyone know if the regular delta 1010 is supported?

[Rob Eko]

the 1010 is not officaly supported but if you get the demo to work with it then it should work .... and i belive the reason the older cards are not supported beacuse they are trying to sell the new ones

[shayne O]

Ok. I have a Delta 1010lt. I've downloaded the demo, and it just says it cant find m-audio hardware (I have the latest drivers).

Is there a trick to getting this to work?