MTC from PT to DM-3200

[Bottomend]

I have added the guide for setting up MTC to the manuals section.

Here is a small representation;
DM Set-up
1. Press the Automation (2) button; this will take you to the
Automation Set-up screen.
2. In the Automation Set-up screen Cursor down to MTC (USB)
and press Enter
3. Press the ALT button so that it is lit then press the Midi (8)
button.
4. Cursor down to USB: 3 MTC and make sure the lines within the
boxes to the left are straight across.

Pro Tools Set-up
1. Launch Pro Tools
2. Click on Setup in the top right of the screen then click on
Peripherals.
3. Click on the Synchronization tab and click on the drop down
menu under MTC Generator Port and choose Tascam DM-
3200 Port 3 or Tascam DM-4800 port 3. (On a PC these ports
will show up as USB Audio Device 3)
The DM3200 or DM4800 should now be receiving Midi Timecode
from Pro Tools.

Good Luck...............Bottomend