192 DB25 pin assignments?

[Studio Dweller]

I'd like to wire up an extra cable for the -10 analog inputs on the 192. Could someone tell me what the pin assignments are?

Thanks.

[doug_hti]

go to the tascam web site, under general, it says the db25 pinout...

http://www.tascam.com/products/downloads.php

[ragbor]

They are listed on page 34 of the 192 I/O Guide and are the same pin configuration as the +4 ins and outs.

As follows: Channel # : Hot # - Cold # - Gnd #
1:24-12-25
2:10-23-11
3:21-9-22
4:7-20-8
5:18-6-19
6:4-17-5
7:15-3-16
8:1-14-2

No connection on pin 13.

I don't know what the MH1/26 and MH2/27 means but it shows them connecting to ground. What are they?

Also note on page 6 about lifting the negative terminals for unbalanced -10 gear.

[Studio Dweller]

Thanks for the replies. I'm still waiting for my HD stuff to arrive so I don't have the manual and was looking to make the cable now.

Thanks again.

[Mike T]

I'll second ragbor's question. Anyone know what MH1->26 and MH2->27 mean?

Thanks,

Mike

[TuT]

How can you have MH1 & MH2 as pins 26 and 27 - on a 25 pin connector.

I'm guessing they are for the metal pin housing and the outer shield.

[Andre Knecht]

[…] I'm still waiting for my HD stuff to arrive so I don't have the manual and was looking to make the cable now. […]

All documentation for Digidesign products is downloadable from the site. In fact, there’s a link to the appropriate page at the top of every DUC forum page (“Technical Documents”). It’s free, well organized, and doesn’t require membership in secret societies.

Heck, you could get a head-start on things and be on top of installation procedures by the time your stuff shows up.

IHTH.

.