|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
||||
|
||||
Satellite Connection message over and over
Every time I launch PT8.
"Could not create network sockets for Satellite connections. The TCP/UDP communication port may possibly be in use. Would you like to try again?" Same warning happens when I choose Peripherals. Have had some crashes when going into Peripherals. This just started happening after I installed cs2. Went back to cs1 but still happening. Not a tragedy but annoying. Not sure what I've done differently to suddenly start this. |
#2
|
|||
|
|||
Re: Satellite Connection message over and over
if you look at the last page in perences. The syncronization page. There ia groupo of Satalite choices checked off when PT 8.0 is installed. I turned these off and that message went away. Not sure if that definitely did it but it worked for the moment
|
#3
|
||||
|
||||
Re: Satellite Connection message over and over
Thanks, I already did that though. I click no and it doesn't come up again until I either go to Peripherals or quit PT and launch again. It's just annoying.
|
#4
|
|||
|
|||
Re: Satellite Connection message over and over
Mee too!!! But is a PT problem or a bad integration with MAC Firewall?
I did both, joji hints and telling firewall to make enable connection as default. Nothing make the annoying message stop. pleeeeeaaaase give us a soloution or a workaround. All the best
__________________
Ciao Eriberto |
#5
|
|||
|
|||
Re: Satellite Connection message over and over
i'm getting this same error everytime as well...
|
#6
|
||||
|
||||
Re: Satellite Connection message over and over
Did you check the settings for Satellite? Go to PERIPHERALS and click on the SATELLITES tab on the far right. Make sure ALL of the Sytems listed show NONE in the pull down menus.
__________________
Eric Seaberg • San Diego, CA A.E.S., I.E.E.E., S.M.P.T.E., S.P.A.R.S. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Satellite dropping connection ! | TommyT | Pro Tools TDM Systems (Mac) | 11 | 01-18-2012 07:00 PM |
ProTools 8 - Video Satellite Connection Error ? | AAR | Pro Tools TDM Systems (Mac) | 11 | 06-05-2011 07:12 PM |
ProTools and Avid Satellite connection problem | tfa | Pro Tools TDM Systems (Mac) | 2 | 06-02-2010 12:47 PM |
ProTools and Avid Satellite connection problem | tfa | Post - Surround - Video | 6 | 06-02-2010 12:46 PM |
Video Satellite LE - Enable Satellite Mode is greyed out? | Erik Olsson | Post - Surround - Video | 6 | 01-11-2010 09:16 AM |