going back to 7.0, transport record lock is no go

[JC925602]

Chasing 3 DA-88 with LTC, PT 7.1 cs6 and cs5, Sync I/O, dual 2 GHz G5, 1.5 Gg of Ram, Mac OS X 10.4.3

Transport Record Lock is ON
Track Record Lock is ON
Record at Time Code Lock is selected.

Every time there is a time code jump, PT transport goes out of record mode.

Strangely it did work partially with a session that had a start time of 20:57:00:02 but in the end I had a session with two blocks missing in the middle and at the end. The session starting at 08:00:00:00 was a no go; or all other sessions.

I did the usual trash digi pref, database...

I just don't want to baby-sit ProTools and restart the record at every time code jump.

I will have to re-install 7.0. I just erased it last week of the backup boot drive to backup the "working" 7.1 just before we did some OS upgrade and install new plug-in.

Anybody have a solution other than reinstall 7.0???

JC

p.s. I had no answer in the "Pro Tools TDM Systems on Mac OS" forum.

[wheresmyfroggy]

Not sure if I'm barking up the wrong tree here but have you got 'jam sync' ticked in session setup? This may help.


HTH

Tom

[Craig F]

what is your freewheel setting?

[JC925602]

what is your freewheel setting?

I tried with 8, and I tried with none. I did not tried jam sync, as it would ignore incoming time code.

JC