|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
cannot get limiter to limit!! help
i cannot get the audiosuite limiter II or the newer comp/limiter III to brickwall limit to a set level.
ratio set to 100:1 fast attack hard knee fast or slow release....if i set the threshold to -2.5dB i still get levels that go to-1.7dB why don't these limiter plug-ins limit? |
#2
|
|||
|
|||
Re: cannot get limiter to limit!! help
...and you never will. As long as there is time for the signal to pass during the 'attack' time, it will go over the set limit. That is why the Waves L2 is so widely used (Life's to short for ==>> WUP ). Maxim gets close, Ozone 3 seems to get even closer. Ask youself what levels you need to get too. If you want squashed to the ceiling, you'll have to invest. Sony Inflator... others? You are asking in the right forum.
|
#3
|
|||
|
|||
Re: cannot get limiter to limit!! help
Yes fast transients will slip right by the Digi limiter.
If you can't spring for a new plug you can dupe your tracks, and slide the dupes forward. Then put the limter on the dupes, and key it off the muted originals. You'll have to play with the timing a bit, but it is a viable workaround. I usually save this for the "mastering" stage. |
#4
|
|||
|
|||
Re: cannot get limiter to limit!! help
i can never get maxim to limit either..... ozone seems to work pretty well
|
#5
|
|||
|
|||
Re: cannot get limiter to limit!! help
if you dont want to spend the extra cash, why don't you just drop your master fader by the amount that is going over the threshhold?
__________________
Matt Perrott Sound Designer and Engineer Sydney, Australia |
#6
|
|||
|
|||
Re: cannot get limiter to limit!! help
curious, why do you want a brickwall limiter?
|
#7
|
|||
|
|||
Re: cannot get limiter to limit!! help
Quote:
I assume this poster wants a brickwall/look-ahead limiter for a legitimate reason like increasing the RMS level of the material at the expense of transient response. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
soft-limiter on mbox 3 soft-limiter.. overdriven tape saturation sound | mjhann83 | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 4 | 07-07-2011 09:01 AM |
LImiter on audiotrack Vs Limiter on auxiliar track | cinetj | General Discussion | 2 | 07-15-2008 11:15 AM |
Where is Limiter in 7.3 ?? | love_me_twotimes | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 9 | 12-13-2006 07:35 AM |
Oxford Limiter vs TC brickwall limiter | stargazer | Pro Tools TDM Systems (Mac) | 3 | 04-28-2006 12:32 PM |
Waves L1 limiter vs. Focusrite D3 limiter??? | Danny Caccavo | Pro Tools TDM Systems (Mac) | 1 | 05-01-2000 12:14 AM |