ML2.0.1 @ AMIII

[Ivan G Castro]

My ML don't recognize AMIII,When I select in the hardware set up AMIII,I don't have sound,
I can oly get sound when I select Mac Internal Sound Card. maybe the AMIII is in the wrong slot (My AMIII is in O slot.)

[Oliver M]

I installed my AM III in slot 1, slot O is used by my graphics card. Maybe you try slot 1?

[Larry LaLonde]

If your using Digi System INIT 3.2.3 and the AMIII card there is a known problem. Either install DSI 3.3, revert back to 3.1.1 ect, and or wait for the release of PT's 4.2.
Good luck,
Larry

[J Cuniberti]

Same here, I will move to slot 1 and advise. By the way, I could not download INIT 3.1.1 from Digi site as of 7/15.

[J Cuniberti]

No change in slot 1. I guess I will have to pay more money to get what was promised..right?

[DigiTechSupt]

Again, Larry is correct. Changing slots is not going to remedy the problem between MLCD 2.x and DigiSystem Init (DSI) 3.2.3 on the AM III card.

I'm not sure why you were not able to download DSI 3.11 from our website but there is no cost to do so. You may want to try to download it again, if you are still unable to successfully download it let me/us know and I'll email it to you.

Thanks,
Jon Connolly

[J Cuniberti]

Is Larry right about 4.2 fixing this problem?

[J Cuniberti]

Well, It's been a long hot month and I guess I have my answer........thank you