move HD3 with HDX and 192 with HD IO

[HiLoc]

I replace my HD3 with a HDX and 1 of my 192 with a HD IO 8x8x8

I'm on PT 10.3.10 OS 10.8.5
The out of HD IO are perfect
The in of HD IO nothing comes in the DAW but well on the meter of the HD IO

For the 192 connected as expansion peripheral
The out are moved of one out or swap B 3-4 with B 5-6

[albee1952]

For troubleshooting, I would simplify a bit. Disconnect the 192 so only the HD IO is connected. You say the outputs are working? Open the IO setup>Input tab. Delete all the input paths. Then create 8 mono inputs and "connect" by the grid matrix to the 8 analog inputs and test just those inputs. If they work, then shut it all down and connect the 192(which can connect to the HD IO expansion port, or directly to the other port of the HDX card) and add only the 8 analog inputs(same as above on the HD IO). Remember to connect the Loop Sync BNC cables.

[HiLoc]

Originally Posted by albee1952

For troubleshooting, I would simplify a bit. Disconnect the 192 so only the HD IO is connected. You say the outputs are working? Open the IO setup>Input tab. Delete all the input paths. Then create 8 mono inputs and "connect" by the grid matrix to the 8 analog inputs and test just those inputs. If they work, then shut it all down and connect the 192(which can connect to the HD IO expansion port, or directly to the other port of the HDX card) and add only the 8 analog inputs(same as above on the HD IO). Remember to connect the Loop Sync BNC cables.

I'll try to morrow

[HiLoc]

oups I've modified the input wirh 8 mono routed as useal via my neve summing, the VU in show signal but in PT not any of the 8 inputs are showed

WRONG AFTER RESTART IN IS SHOWING IN THE DAW CORRECTLY

For the mismatch of output on the 192, it was a nightmare in the bus list in the IO setup menu

Many thanks for you help