Using Digi 003 and Kemper Profiling Amp

[Raoul23]

Kemper has to be master clock and are you using latest firmware on the kemper they released an update that sorted clicks on the SPDIF


Sent from my iPhone using Tapatalk

[Alexrkstr]

Originally Posted by Raoul23

Kemper has to be master clock and are you using latest firmware on the kemper they released an update that sorted clicks on the SPDIF


Sent from my iPhone using Tapatalk

Hi Raoul, I have it as the master, connected with the proper spdif cables, with the latest 5.3.1 firmware.

[Darryl Ramm]

Originally Posted by Alexrkstr

Hi Darryl - thanks again for the reply. Yes, I am using a set of 3ft long LiveWire SPDIF cables that are pretty much brand new. I've tested it with a third cable and the same annoying click/noise is present.



The setup for SPDIF works with the 11r, but I'm not sure what the settings that are making it work are (I'm running the 11r at 48kHz).



Interestingly enough... I had this exact problem with my POD HD Desktop and that's why I ended up selling it.

Yes but clicks when you are not clocking from the S/PDIF in are expected. This is not helping, you need to debug why you cannot clock from that. Set that up, confirm that is set in hardware setup, double check the session sample rate. Then if it is not working hot swap the S/PDIF cables, hot swap for another S/PDIF device etc.


Sent from my iPhone using Tapatalk

[albee1952]

FWIW, having recorded the Kemper thru SPDIF on a DIGI002 and thru a Chameleon Labs 581 mic pre, the analog path sounded much better