|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
EQ3 on a Stereo Aux Track
Is this possible? I would really like to use this EQ on aux stereo tracks but it is not available as an option. I looked up the documentation of the plug in and it says that stereo operation is only available using mono-multi mode. I'm not quite sure what mono-multi operation is. I'm sorry if this sounds like a dumb question but I just haven't been able to figure this one out.
|
#2
|
|||
|
|||
Re: EQ3 on a Stereo Aux Track
Multi-Mono means it will run two instances of the plug-in (basically).
Single gui tho, which then allows the controls to be operated linked, unlinked, etc. Plug-ins manual should go over this pretty well.
__________________
nikki k Eagles may soar, but weasels don't get sucked into jet engines. On the other hand, you have different fingers. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bussing Efx to Aux Track and then bounce project to a Stereo Track | arb232 | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 12 | 01-06-2012 06:17 AM |
On a stereo audio track, the left track is completely dead | ckwhy2008 | Pro Tools M-Powered (Mac) | 1 | 04-09-2011 04:16 AM |
Conver stereo track to SINGLE mono track | markolone | Pro Tools M-Powered (Win) | 1 | 07-30-2010 07:09 PM |
Stereo track vs. Mono track vs. Stereo Interleaved track >>>>>>>>>>> | peter parker | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 18 | 06-26-2002 03:21 PM |
can you not copy automation data from a mono track to a stereo track? | Felix | Tips & Tricks | 5 | 04-09-2002 06:32 PM |