New Devices Aggregate Help needed

[db0007]

Hello all,

PT 11.3
Mac OSX 10.10.1
2.3 i7
16GB Ram
Apollo Interface

This Aggregate thing is new to me. I just installed the FW card in my Motif. My Interface is an Apollo, I also have a 2ch AD/DA on the Spdif and 8ch AD/DA on the ADAT. Everything is showing up Audio Setup and a rough test got the Motif to work. So I go to create a new template and found a issue.

In Aggregate it shows I have 48 ins including 2 HiZ inputs, 4 Virtual and MON from the Apollo. Why MON is in Ins and not Outs beats the hell out of me. Any how in total its showing 48 Ins.

In PT I/O its showing Analog Ins 1-25 and Optical 26-32.

The base template for the above I got from Yamaha. If I have my previous everyday template it only shows my 8x8x2 (which I obviously deleted paths at some point).

Now from what I'm reading I can only add/remove/rename devices in HD. I'm guessing I'm going to need to create a full new template from scratch, no problem. But how do I figure out whats what on the Ins if they obviously aren't matching up to the Aggregate layout.

I tried searching this regarding Motif set up but just about everything I'm finding is for a 003 or a Mbox. With 2 additional converters hooked up and Apollos unique layout due to console I'm really lost and don't know where to begin.

Any help will be greatly appreciated!

[db0007]

SMFH Motif was turned off. #fail ... All 48 showing up in PT I/O now. How do I figure out which IN is which seeing as how analog is split in 2?

*Note* Analog Spdif ADAT etc unable to be assignable in non-HD

[db0007]

Figured it out!

Mod close thread

Thank you!