audio track missing pan control???

[davidp158]

I was working on a new session last night, and at one point I added two audio tracks, and recorded di and mic'd bass to these two tracks. I went to check them in mono, and noticed that one of them didn't have a pan control.

I didn't notice if this was the case when the tracks were created, so I assume I must have disabled the pan control somehow. Is there a keyboard command for this? I couldn't find a way to add the pan control, so I made a new audio track and moved one bass track to it.

regards,
Dave Patterson / Knobville

[Delapintas]

[img]images/icons/wink.gif[/img] Be sure you set the output to two outs and in preference panel, make sure stereo outputs is enabled.

Hope this helps

[davidp158]

Thanks for the reply. I created the two tracks, recorded on them, and then went to pan them. It was at that time that I noticed one didn't have the pan control. One track had a pan control, the other one didn't, yet they were created at the same time. When I created a new, blank track, it had a pan control, as expected. I haven't made any changes to the outputs (default is stereo). Strange, huh?

dp

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:<HR>Originally posted by Delapintas:
[img]images/icons/wink.gif[/img] Be sure you set the output to two outs and in preference panel, make sure stereo outputs is enabled.

Hope this helps<HR></BLOCKQUOTE>