|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
|
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
Cut Only EQ clipping light after brickwall limiter on Master Fader?
Both Oxford EQ and EQ III are showing clipping on their outputs with cut only settings (i.e. -4 @140hz). They are after an x3 with it's ceiling set to 0.1 db and then a Massey 2007, even with it's maximum output control lowered a notch or two. The master fader is at 0.
Are the EQ's clipping with only cut? Do their clip lights show clipping at a lower level than the massey. Do cut only EQ settings result in some boost at the edge/shoulder of the cut that could cause this? Lowering the EQ output volume sufficiently stops the clipping indicator. The more the cut, the greater the output volume has to be lowered, and the average indication on the output level is notably lower than the input level. How can I trim a bid of low end mud from the mix without lowering the overall volume, or changing the limiting (which would happen if the EQ's were put ahead of the limiters? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MD3 and Brickwall Limiter - How to prevent bus clipping? | rantanplan | RTAS & TDM Plug-ins | 1 | 07-04-2013 04:22 AM |
master fader limiter -help me buy | cary chilton | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 21 | 02-11-2007 03:51 PM |
Fixing Clipping in Master in Master Fader | pakobo7 | Pro Tools M-Powered (Win) | 10 | 09-16-2006 10:53 AM |
Master inserts are post-fader? Was: L1+ on Master = clipping | s2n | Pro Tools TDM Systems (Mac) | 10 | 11-20-2001 07:41 AM |
Limiter Settings in a Master Fader | Mark_Knecht | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 4 | 11-11-2001 06:46 PM |