ProTools 2020 HUI support

[courtsong]

Has anybody successfully achieved full functionality on a Mackie MCU Pro connected to Pro Tools 2020 via HUI? https://www.pro-tools-expert.com/hom...must-read-this suggests it is no longer supported. I've checked the configuration in the article, and I'm not running EUCON so it doesn't seem relevant.

Here's the current functionality I'm getting from the MCU pro
Stop/play/fforward/frewind supported
Jog wheel not supported
Faders control the mixer
Pan knob controls panning
I can't make an exhaustive list because there was so much the MCU Pro could control on older versions of Pro Tools. The most irritating symptom is the red LED Counter indicator on the MCU Pro is flickering Klingon numbers (but the LEDs are fine connected to Reason or Logic using their protocols)

Has anybody gotten full functionality out of the MCU on Pro Tools 2020?

What was the last version of Pro Tools with tested and verified HUI support for the MCU Pro?

Thanks in advance!

[DetroitT]

Full HUI yes
MCU no

If using with eucontrol you will loose VU metering in HUI.
Just untick eucon and meters ate back.

[Southsidemusic]

Same with our 4 units of ICON Pro G2 series and works great in our midi room