No playback sound after recording

[andisheep]

This is very frustrating... I can record with monitor but it doesn't playbck....

The interface Im using is Duet 2, and I've been recording vocals fine with Garageband and there has been playback after recording. After installing Pro Tools 10 and activation and everything, I can record vocals and everything seems to be fine, I changed the playback engine in Setup to Duet and IO input and output seem to be right, and monitor is on, everything sounds fine while recording, and the initial beep sound to indicate the beginning of recording can be heard. But after the recording, I click play and there's no playback sound, which is very frustrating, as if the output is put to sleep, and no sound would come through any other audio resource either, for example if I open iTunes and there would be no sound. And then I have to quit Pro Tools and open it again and start all over again so there would be sound while recording, but still no playback sound again and the output is dead again. I've already uninstalled Pro Tools and re-installed it but the same problem still happens. It never happens if I'm using garageband.

I don't have an external hard drive at the moment but the computer has 250G space partitioned..... should that be the problem?

[Phil Ogden]

1. Are you attempting to record to an AUDIO track not an AUX?
2. have you selected the appropriate input to the audio track?
3. Is there a waveform created?
4. Have you tried playback without the track record enabled?

[sunburst79]

Toggle input Modes with ALT+K

[andisheep]

Originally Posted by Phil Ogden

1. Are you attempting to record to an AUDIO track not an AUX?
2. have you selected the appropriate input to the audio track?
3. Is there a waveform created?
4. Have you tried playback without the track record enabled?

1 I was trying to record a vocal audio track through the template
2 i think the input was fine because i could record with monitor on and the waveform showed normal
4 I have tried without the track record enabled but there was still no sound

[Phil Ogden]

It sounds like you are getting a signal to the channel and recording it. Therefore, I would look at the channel output. Is it mapped correctly say, Analogue 1&2 and is this set to output through the Duet?

[Markk]

If you have input monitoring on you will not hear playback.

[andisheep]

Originally Posted by Markk

If you have input monitoring on you will not hear playback.

good point, and it did seem to be the problem, cuz whenever i clicked play there seemed to be volume but full blast and no sound. but i switched to auto monitoring on but still didn't work... is there a way to turn it completely off ? ....

[andisheep]

Originally Posted by Phil Ogden

It sounds like you are getting a signal to the channel and recording it. Therefore, I would look at the channel output. Is it mapped correctly say, Analogue 1&2 and is this set to output through the Duet?

yes that is exactly my output through Duet. and i can hear playback if i only play an audio backing track without recording, there's no sound only after recording..... so every time after recording, no any sound would playback....