003 Replacement?

[gscaife]

Does anyone know of a good FW board compatible with protools 11?

I'm looking for a compatible console with physical faders to replace my 003 console.

My setup now:

Mavericks 10.9.4
MBP 15-inch (Late 2011), 2.4.GHz Intel Core i7, 16 GB RAM
Focusrite OctPre MK II Dynamic
Digi 003 Console
003 driver 10.3.3
Protools 10.3.9

[albee1952]

Good luck For control surfaces, there's not much to choose from(personally, I have high hopes for the Behringer X-Touch, if they ever actually ship them). Artist Mix and/or Artist Control are worth a look, but do cost more. I just replaced my 003 with an HDN package, and while I do miss the surface, my little Presonus Faderport covers transport, quick-punch and fader rides just fine. In fact, the button I miss the most: SAVE

[LaForestGray]

Do you need I/O from the new interface or just fader's/pan/plugin, etc,. control?

Look at the Focusrite Control 2802:

"The best of both worlds! The Focusrite Control 2802 is both an analog mixer and a DAW control surface. Eight high-bandwidth, low-noise Class A mic preamps start the signal chain of this dual-layer mixer. A total of 32 inputs is possible, so you can record as large an ensemble as you want. The Control 2802 also adds a stereo mix bus compressor, a myriad of routing options, and motorized 100mm Alps faders to your studio - in one complete package. This high-end analog summing mixer also features phantom power, a full-featured master section, dedicated stereo bus cues, and a 10-LED channel meter for ease of use."

http://www.sweetwater.com/store/detail/Control2802

Hope this helps